Anti-Slip Grip ø 22 mm

Anti-Slip Grip for handles.

1 x 33 cm long.

ø 22 mm fit to eg. Driving hammers, fullers and stamps. Shrink down to 11 mm.

Comparing to other grips, this is in one piece and there is no adhesive on the grip, so it doesn’t start to curl up and be sticky after a few times use.

It is only 1 mm thick, so the handle will not feel thick in the hand.

Instructions for applying:

Cut the grip to the desired length. (it does not shrink in length)

Slide the grip onto the handle where it must be mounted.

Heat up the grip. Most effective is the use of a heat gun, but also possible to use boiling water, or to keep it close to fire in a forge.

Distribute the heat evenly around the grip until it begins to shrink. Continue with an evenly heat until the grip is shrunk so much that it is stuck.

Be careful not to overheat, as this may damage the product and then it will not be possible to shrink it evenly onto the handle